Amplifiers

If you want to get the maximum performance from your loudspeakers and subwoofers, definitely add a Polk PA D amplifier or two. We offer 2-channel, 4-channel, 5-channel and monoblocks. Each PA amp is styled lean and plays meaner, with enough big, fat juicy watts to drive your system so you get to hear all of your music, no matter where and how loud you like to play.

PA 880 Mono Amplifier

High performance monoblock mobile audio amplifier

The PA880 is a single-channel class A/B amplifier with built-in fully variable low-pass crossover. The PA880 monoblock is equipped with optional remote bass EQ control and is capable of one-channel operation with a maximum power of 800 Watts into 2 ohms.

RRP $429.00 AUD

Product Manual

Monoblock amplifier for subwoofer use.

300 Watts x 1 (4 ohm), 500 Watts x 1 (2 ohm).

CEA-2006 compliant specifications for true, accurate power ratings.

800 Watts x 1 (2 ohm) dynamic power.

2 ohm stable design can drive even the most demanding subwoofers.

Power and ground terminals accept bare wire up to 4 AWG. Terminals use standard #2 Phillips head screwdriver-no more hex wrenches to lose or strip!

High-speed MOSFET switching power supply and high current bipolar output transistors pump maximum voltage and high current to your speakers or subwoofers.

Double layer fiberglass epoxy printed circuit boards for more rigidity, less shrinkage and a smaller overall amp footprint.

6-way Smart System Protection (SSP) circuits.

Switchable 3-position bass boost (0dB, 6dB, 12dB) for extra bass thump.

Switchable 180° phase inversion for easy sub to main integration.

RCA outputs for easy daisy chaining of other amplifiers.

Mounting hardware with rubber isolation grommets and extra fuses included.

Light bar/fan output-connect an optional LED light bar or cooling fan for custom installations.

Status LEDs give instant information on amplifier operation.

Electrical

Total Frequency Response 10Hz-30kHz 
Signal-to-noise (Referenced to rated power) 80 dBA
Distortion at Rated Power 0.9 %
Minimum Impedance Bridged 4 ohm
Minimum Impedance Not Bridged 2 ohm
Low Pass Filter
Filter Slope 12dB/oct 
Filter Frequency 50Hz-500Hz 
Effective Damping Factor >150 
Max Sensitivity 200mV-5 

Amplifier Specs

Channels
Channel Notes Class AB MOSFET 
Total Dynamic Power 800 watts
Bass Boost Characteristics 3-position(0,6,12dB) Hz
12V & Ground Cable Gauge 4AWG 

Shipping

Total Shipping Weight 9.80 pounds

Amplifier Power Specs

RMS Power at 14.4V
Watts per channel NOT bridged @ 1 kHz
4 ohms 300 watts
2 ohms 500 watts
Dynamic Power at 14.4V
4 ohms 500 watts
2 ohms 800 watts